Round over thin bits

Hi all , I'm on the hunt for a round over tool with bearing or similar, to edge 4.5mm acrylic , the only mini micro ones I've found still need thicker material to work, if it was just a one off I would sand but this is for a shop, looked at the dremel round over bits but don't think they will go that thin, any ideas would be greatly appreciated
Cheers all.

Riche

Hi, you should build yourself or buy a router table and use a full radius cutter, you can use it to full cut or just a small portion of it to break corners.


This it way better than using a hand router.


Jeff