Good morning all,
I looked over the website and even the DOCs but still not sure (perhaps because I want this)...
Is the UCC software able to control lathes?
Can two MPGs be used at the same time with the UCC software?
Thanks
Chris
Printable View
Good morning all,
I looked over the website and even the DOCs but still not sure (perhaps because I want this)...
Is the UCC software able to control lathes?
Can two MPGs be used at the same time with the UCC software?
Thanks
Chris
There is no lathe mode, but some people have used it for lathes.
UCCNC currently only supports one MPG.
Thanks Gerry,
I was afraid of that. I guess it is time to look into LinuxCNC.
Chris D