Boss Laser LS 2436

Hey guys, new to the forum & have issues,

I purchased a Boss LS2436 laser engraver/cutter & i'm finding that their cutting speeds are dif than most other companies, they are in mm/sec as opposed to %of speed (on a trotec/epilog)

Anyone have an idea on the comparison ?
I thought of calling them and asking, but they'd probably tell me to go kick rocks since i didn't buy one of their machines....

2nd: the table comes with numbered scales, top & right side, but they are flat, not able to bank any work pieces against for alignment /re-positioning of work, did anyone make their own and mount them ?


Thanks in advance !!!

Im sure you have the answer to your questions already 4 years later , but full speed is 500 so as a percentage of 500 tells you the speed to set, I was wondering if you may have had any issues with replacing your lens and then precision and power being an issue, just had to replace my lens , it cracked after engraving 25 hockey pucks, and now with the new lens isnt as defined in precision engraving and seems to need more power to do the same jobs