mach3 post forASPIRE ON ROMAXX HS1

Does anyone have a post processor for a Romaxx HS1 in Aspire 4.0 usimg Mach3?
Thanks

You just use the standard Mach3 posts. There's nothing in an Aspire post processor that would be specific to your Romaxx.

I upgraded from 3.5 to 4.0 and its adding tool changes to the code and I am using the Mach3 post with no ATC.
also my z has lost its position as I start the the program its shows a t/c and I press start again and the z goes to
the top and and trys to keep on going then it wants to drive to the table.It never did that before I upgraded.I am
new to mach3 and Aspire so it could be error on my part?

What post are you using?

I am using the non ATC Mach3 post.But its adding t/c and wont hold z zero wants to drive out of z limits +and-.

I use aspire4, with mach 3 _ATC and non ATC depending on the project. When I select multiple toolpaths with different tools and non_atc selected, aspire gives me a warning and does not allow saving the file. I must select the ATC processor to proceed. Are you saving multiple toolpaths with different tools into one file?

Sent from my Transformer TF101 using Tapatalk

Yes you just use mach 3 pp for your romaxx mschine...OTE=macatoms;1436012]Does anyone have a post processor for a Romaxx HS1 in Aspire 4.0 usimg Mach3?
Thanks[/QUOTE]

You need to change setting in mach3
...ignore tool change

Thsts what i do...otherwise z will move up 1in and csn cause major issues