Can not drip feeding fanuc OM (128 ps alarm )
Hi
I have just bought a milling machine with fanuc om control.My control has a tap mode switch and when i choose the tap mode the control shows AUTO ,when i press cycle start the control flashes LSK ,and from the computer I started to send the nc file .
the result was 128 PS ALARM .:mad:
I made a lot of rs232 cables for fanuc om control and I changed the parameters for dnc but it show always 128 PS ALARM.
Someone told me to use another post processor but it also fails.
P.S. G127.5 IS 1 WHEN I SWITH TO TAPE MODE!
Could anyone help me to start drip feeding ?:bs:
Re: Can not drip feeding fanuc OM (128 ps alarm )
Are you calling a subprogram in your program?
Re: Can not drip feeding fanuc OM (128 ps alarm )
No I am not calling a subprogram in the program that I want to drip feed with the control.
when I try to drip feed with the control (tape mode) I got 128 ps alarm
when I try to upload a program to the control I got 85 ps alarm.
Iam using cimco edit and easydnc
I just used a lot of rs232 cable and changed 002 , 552 paramteres .
please help
Re: Can not drip feeding fanuc OM (128 ps alarm )
Fanuc alarm: PS128 - SEQUENCE NO. OUT OF RANGE
Machine Alarm Error & Message:
PS128 - SEQUENCE NO. OUT OF RANGE
Fanuc's Alarm Description: Sequence number is other than 1 - 9999.
Additional Suggestions & Alarm Clarification:
CNC Programming problem
Fanuc alarm: 85 - COMMUNICATION ERROR
Machine Alarm Error & Message:
85 - COMMUNICATION ERROR
Fanuc's Alarm Description: When entering data in the memory by using Reader / Puncher interface, an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is in correct.
