Connecting 2 different spindles/vfd to one BOB
Hello,
I would like to use a second spindle on my dual z setup instead ot the spindle/router setup i have now.
The problem is i don't know howto approach the connection of the second spindle onto the BOB.
On the BOB(avid cnc/cncrp) i only have one spindle relay and one 0/10v vfd steering.
Both spindles are different :
spindle 1 max freq of 400hz / 1x220v
spindle 2 max freq of 300hz / 3x220v
Any help would be apreciated!
Stay safe,
Adam
Re: Connecting 2 different spindles/vfd to one BOB
Nobody that can send me in the right direction?
1 Attachment(s)
Re: Connecting 2 different spindles/vfd to one BOB
Quote:
Originally Posted by
DAAD
Nobody that can send me in the right direction?
You just need to add another spindle control board does not matter if the spindles are different the control side does not change only the parameters set in the VFD Drive
An add on board like this will do the job or any other similar one's
Re: Connecting 2 different spindles/vfd to one BOB
thanks for the input!
After talking with a friend who is an electronic engineer, he suggested to work with 2 relay's to swith the on/off and the 1/10V signal with another output signal.
I've ordered an 8 relay SPDT and will try it this way first.
Keep safe,
Adam
Re: Connecting 2 different spindles/vfd to one BOB
Quote:
Originally Posted by
DAAD
thanks for the input!
After talking with a friend who is an electronic engineer, he suggested to work with 2 relay's to swith the on/off and the 1/10V signal with another output signal.
I've ordered an 8 relay SPDT and will try it this way first.
Keep safe,
Adam
I though you wanted to run both spindles at the same time, if so you can't do that with just switching the same outputs
Re: Connecting 2 different spindles/vfd to one BOB
Both spindles do not run at the same time, but serve as a "toolchanger" with 2 tools
At the moment i'm using a relay to switch contact between spindle on and router on. I suppose it would be possible to "swap" the 0-10 V signal also.
In mach 4 i think i can setup a second spindle with different configs?
There will be some programming needed.