The controller is working with Fanuc 10m. I need to find a way to backup the parameters. Does anyone have a manual or a "how to backup step by step" for the Fanuc 10m?
Printable View
The controller is working with Fanuc 10m. I need to find a way to backup the parameters. Does anyone have a manual or a "how to backup step by step" for the Fanuc 10m?
Punch out Parameters:
Select SERVICE screen.
Press PUNCH.
Press ALL.
Write down Option Parameters (or check if they were sent out with the parameters):
NC PRM #9000Number of axes
#9100-9116 / 9100-9132 Option parameters (depending on model).
Write down PMC Parameters (NC/PC):
Timers
Counters
Keep Relays
Data Tables
Positioning Module (if present)
Punch out Programs:
Select EDIT mode.
Verify Program Protect Key is OFF.
Select PROGRAM (MEMORY) screen.
Press PUNCH.
Press ALL.
Punch out Tool Offsets:
Select EDIT mode.
Select OFFSET screen.
Press PUNCH.
Press TOOL.
Again, make SURE you have Option and PMC parameters!
You will also need your 8000 and 9000 programs. These have a parameter that locks them so make sure that they get backed up. They will not “punch” out of the control if they are locked.
To be able to write, punch or edit 8000 programs, parameter 0011.0 (bit 0) to a "0", for 9000 programs, 2201.0 to a "0".