Charmilles Roboform 200 - HELP!
Hi Guys.
I bought an old Roboform 200 and the digital power supply. a Weir SMM 200 NT, is dead. Does anyone know what the supplied amperage's are for each of the output voltages: +5VDC, +12VDC, and -15VDC?
This brings up another issue. The Weir power supply provides -15VDC and routes it to a terminal block that is labeled -12VDC. Is it really -15VDC or -12VDC? If anyone could measure the voltage at the -12VDC terminal block relative to chassis ground (or the O with a slash through it on the terminal block). The terminal block is located right below the Weir digital power supply.
When I say "digital power supply" I mean the power supply that powers the back plane of the computer card file.
Thank you for all your help.
Best Regards,
Paul Hoffman
Supplier for Power supply
Where do you get the ASTEC ps from - I called a couple places and they say its been discontinued. Any help would be great......
Terry
[email protected]
Charmilles Roboform 200 control panel
I have a Charmilles Roboform 200 with a bad control panel.
Guess what, that part is unavailable. I'm planning on cutting into the ribbon to access the wires needed and install an on/off switch. I have been told this machine (1991 model) is obsolete. Seems a shame to have a $200,000.00 machine unusable because they quit making parts.
Does anyone have hints about where to look for such items?
Re: Charmilles Roboform 200 - HELP!
Hello to everyone, I have a problem with my Charmilles Roboform 200!
when the program starts, the machine gives me an alarm : 814 V illegal
-I cleaned all the contacts
-all voltages on the source are ok
I have no documentation about this machine
Please help me to solve this problem, or with a wiring diagram for this machine
Thank you
Re: Charmilles Roboform 200 - HELP!
Hi,
the manual for the errors of a generator says: A814, V incorrect (trop grand), Corrigier la valeur (Correct the value). I can not help you more. Maybe you can contact Justin Purdun over Linkedin.
Bye.
Re: Charmilles Roboform 200 - HELP!
Quote:
Originally Posted by
habigogo
Hi,
the manual for the errors of a generator says: A814, V incorrect (trop grand), Corrigier la valeur (Correct the value). I can not help you more. Maybe you can contact Justin Purdun over Linkedin.
Bye.
Thank you !
i will talk with Justin