Cannot get the e-stop to reset. If I hold reset button down the drives turn on and I can jog all axis’. I’ve tried swapping relays and did not solve problem.
Any help would be appreciated
Jeff
[email protected]
Printable View
Cannot get the e-stop to reset. If I hold reset button down the drives turn on and I can jog all axis’. I’ve tried swapping relays and did not solve problem.
Any help would be appreciated
Jeff
[email protected]
Check your limit switches to make sure they're not stuck or jammed up with chips. Sometimes my back y/z way cover (curtain type) gets a heavy enough load of chips on it that it sags down and trips the switches. Freaked me out the first time it happened. Stopped mid travel going y minus mid program. There is a page in the parameters that will show on your screen if any are tripped.
Sent from my SM-N960U using Tapatalk
I would think that it definitely could. I don't remember if they're NO or NC, but if it failed opposite of normal operation it would likely cause the problem.
Sent from my SM-N960U using Tapatalk
on my Partner mill , I had wires going to the limit switch that were oil soaked , and insulation bare . This was the wiring under the X table . Shorting to ground will prevent a reset .
On my ML 15 lathe , I tried to reset , and after exploring many possible causes , discovered that there are 2 E STOP buttons . and I hit the one on the sliding door . This switch will "latch on " , and no matter how many times you try to reset the button on the control panel , it will not reset . Kinda stupid mistake , but cost nothing to get up and running again
It turned out to be a bad limit switch in the Z axis..