Hello everyone.
I need a manual for VFD ZONCN NZ200.
I wrote to the supplier. I wrote to the manufacturer and no one answered me.
Can you help me please?
Thanks Jirka
Printable View
Hello everyone.
I need a manual for VFD ZONCN NZ200.
I wrote to the supplier. I wrote to the manufacturer and no one answered me.
Can you help me please?
Thanks Jirka
What is the manufactures nameQuote:
Originally Posted by jirkamm
ZONCN
Thanks
What do you need to know about it I don't have the manual but may be able to helpQuote:
Originally Posted by jirkamm
Hello.
I need to set - "device error" for relay output 1.
Set to relay output 2 - "device on" output
For analog output I need to set - output "Current frequency" - 0-10V.
But it probably doesn't have an analog VDF output.
Thank you
Next, I need to set to control the pump power with an external potentiometer.
I need a clear photo of the low voltage terminalsQuote:
Originally Posted by jirkamm
And no you would not use any of the relay output for a Pot
Tell me what your VFD is being used for and what it is driving
Hi, I have one, how to send it to you?Quote:
Originally Posted by jirkamm
Hi.
"And no you would not use any of the relay output for a Pot" (I don't understand this sentence)
VFD is used to control the vacuum pump power for the vacuum table. I need to adjust the power with a potentiometer. When milling holes and grooves I need to increase performance. I meant to connect the potentiometer and pressure sensor in series.
Thanks
Not a very good photo the +10 AVI and Ground Terminals are what your Pot connects to AVI to the center Pot connection there is also a Jumper or switch that needs to be set J2 to AVI it is beside the terminal blockQuote:
Originally Posted by jirkamm
There may be a Parameter to set also
You can attach it here, open a post, go to Advanced scroll down and attach a PDF FileQuote:
Originally Posted by CNCINDUSTRY
Do you need to controll the VFD dynamically？Then you need a controller which has analog input and output module. Such as PLC.Quote:
Originally Posted by jirkamm
The potentiometer and pressure sensor connect to the controller's input terminals, and its output terminal connect to the VFD‘s analog input terminals.
Awful,size limited.Quote:
Originally Posted by mactec54
Do you need the wiring diagrams? Maybe later.
Please send it to [email protected]. Max. 20Mb.Quote:
Originally Posted by CNCINDUSTRY
Thanks
Jirka
Yes. I need to dynamically. I told the supplier that I needed it this way. The supplier said - ok.Quote:
Originally Posted by CNCINDUSTRY
I see that I can throw away the VFD.
Thanks
Your VFD is not different from any other, I'm sure you could do what is needed if you get creative, your sensor would be controlled from your machine control and would output a voltage change to adjust the VFD Drives motor RPM as needed not hard to do at allQuote:
Originally Posted by jirkamm
It is true. I will have linuxcnc and Beckhoff EL3064 and EL4004 there. That could work.Quote:
Originally Posted by mactec54
Good idea.
Thanks
HiGood Day! I need the manual also, would it be possible for you to share it to me?Quote:
Originally Posted by CNCINDUSTRY