OSP 100 Battery alarm 4035
Hi,
Machine Macturn350 OSP100
4035 ALARM- D Memory board/battery change 2
2) A a certain period has passed since the software was initialised installed
Has anyone instructions for this? Is there date in parameters which should be change after battery replace?
Thanks,
GB
Re: OSP 100 Battery alarm 4035
The battery has a set timer on it that will go off weather the bat is going dead or not. You can go to the battery page in your parameters and advance it a bit to get rid of the alarm temporarily but it’s best to replace it and set the date ahead by the several years as recommended. Was it seven? I forget...maybe my battery is getting weak... ;-)
You will probably have to unhide the parameter page using display change.
Best regards,
Re: OSP 100 Battery alarm 4035
I have not found battery info page on OSP100 ? Which parameter page is it ?
Thanks,
GB
Re: OSP 100 Battery alarm 4035
What is the OSP100?
U100 , E100 or P100, which?
Re: OSP 100 Battery alarm 4035
it's U100L
Model year:2003
Re: OSP 100 Battery alarm 4035
Designer of this battery system has drinked sake. A lot.
I found instructions here:
https://www.practicalmachinist.com/v...cedure-277828/
Biggest problem was to found 3,5 inch floppy...
Good luck to anyone with this problem.
Re: OSP 100 Battery alarm 4035
OSP 100
Is the control model information
Re: OSP 100 Battery alarm 4035
Does anyone have the procedure on how to replace the batteries
on the osp 100 and t he osp 200