I just got my cnc kit and hooked them all up for a test run and there is one that has a blinking green light. I switched the motors around and still the same thing.
any ideas on whats wrong?
Printable View
I just got my cnc kit and hooked them all up for a test run and there is one that has a blinking green light. I switched the motors around and still the same thing.
any ideas on whats wrong?
Poorman56,
Remove the wire connected to the enable.
Jeff...
removed the wire and it still blinks
With power supply off remove all wires except power wires then power back on and see if led flashes.
Did you figure out what as wrong? I am having the same poroblem with my DM542A. I dont have the jumper enable and I see that that was the last comment on the feed...?
Know this is resurrecting a dead thread but I am having the same issue with a DM542S, blinking green light. Followed the suggestions above but the issue still persists. There is NO documentation out there for a flashing green LED on these drivers. Any help appreciated.Quote:
Originally Posted by Tainoworks