I have an OSP5020M with Dnc-B as baurate 4800, I want up to 9600 please help me ..... thanks
Printable View
I have an OSP5020M with Dnc-B as baurate 4800, I want up to 9600 please help me ..... thanks
You should be able to change Parameter word #39 to 9600 if using channel 1. Be sure to wait for about 2.5 minutes for backup to occur automatically and the power down including the breaker for 1 minute to let the RS board reset properly.
Best regards,
Then I would suspect that you are not using channel 1. Check your word#43 parameter to see what it is set to. I believe that is designating which port DNC will use. If 0 then using channel 0 and so forth. If 0 then try setting baud on word#6. Channels 2,3,4 are Word 40,41,42. Change the appropriate one as described before.
Best regards,
Did you follow my exact instructions about powering down with breaker off for 1 minute?
If you did then go to the parameter mode on the machine and type in CMPS and tell me if some “magic” DNC parameters open up.