1 Attachment(s)
Need Help!Tool loading /unloading jammed in Siniumerik 840d controller.
Hi All
I have a problem with a DMG 1032v ecoline machining center with a Siemens 840D controller. It froze during a load tool cycle and now I can't load or unload tools in or out of the magazine. In the magazine location on the offset table there is the LL symbol on that particular tool. This symbol normally shows up momentarily during the load tool cycle then disappears & I am pretty sure this has something to do with the problem. The strange thing is I can still use all the tools in the magazine as normal and can load tool in the spindle manually from the virtual magazine, I just can't load or unload from the magazine it self. I was wondering if there is a hidden parameter somewhere that needs to be reset and if anyone knows it. Any help appreciated.
Note:The snapshot i have attached is not real snap ,it is only for illustration
Re: Need Help!Tool loading /unloading jammed in Siniumerik 840d controller.
So on a DMU50 that toolchanger controls are under the custom menu. There's an icon with a conveyor and tool change arm if my memory serves right. You can return each component to the default position then reset the toolchanger system from there. Look in there and see if you can find it.
If you can't find it I can take a quick video for you next week.
Re: Need Help!Tool loading /unloading jammed in Siniumerik 840d controller.
Hi, well as you said, that can happen when you don't confirm the unloading of a tool.
Hers's what a tech from DMG sent me about that LL problem :
To clear the tool loading memory,
please run the following commands - one by one - in MDI:
$TC_MPP6[9999,1]=0
$TC_MPP6[9999,2]=0
$TC_MPP6[9999,3]=0
In case you get an error message, please try the next line.
Result should be a clearance of the position LL to no position - means you can load this tool, afterwards.