-
Fanuc 18T
Just got a Whacheon Hi-ECO 31A wit the Fanuc 18T control. No book. Can't get the machine to take a program from the computer. We use an old Procom program. I get an alarm, number is 086. Also, the machine has info on using the tool setter, any thoughts appreciated.
Paul in OKC
-
Paul,
An 086 alarm can be caused by incorrect cable wiring from the CNC to the PC.
CNC <-----------> PC
DB25 ----------- DB9
1 <-- shield
2 <---------------> 2
3 <---------------> 3
7 <---------------> 5
Pins 4 & 5 are jumpered on the CNC end.
Pins 6, 8 & 20 are jumpered on the CNC end.
-
I use the same set up to load 2 other machines, a Daewoo Puma lathe with a 15T, and a Haas VF3 machinig center. Tried to match all the numbers in the system set up.
-
What do you have in Setting - I/O Channel (parameter 20)? It should be 0 or 1 for RS-232. What works on the Haas won't necessarily work on the Fanuc, but the 15T cable should work. If your cable is wired with 6-8-20 jumpered then you may have a bad connection internally or a bad comm board.
-
I will check it out. Thanks.
It is at 0.
-
can you send programs from CNC to your PC? If it works in one direction and not the other, most likely not the parameter settings.
-
Nope, tried that too. I feel like we are just missing something obvious. Is there a parameter setting for communication?
-