Okuma VACIII D11 ALARM 20
"1058-20 ALARM A Heat Sink Overload" presents at power up (cold machine) and communication with the drive. Drive LED's M1 and M2 as well as green LED 9 are on solid. Have exhausted maintenance manual and tech support troubleshooting tips up to changing out control PCB, which I don't have Any suggestions greatly appreciated.
Re: Okuma VACIII D11 ALARM 20
Check and clean the fans behind the vac unit. you have tu remove the vac unit. Then you can reach them..
Re: Okuma VACIII D11 ALARM 20
Hello, we repair Okuma drives, power supplies, etc. If you want to discuss this, you can email me at [email protected] is usually a pretty inexpensive fix and one of the few where we will do a "parts and labor" repair to avoid the expense of a full refurbish repair cost.
Re: Okuma VACIII D11 ALARM 20
Thanks for the replies. Yes, I have cleaned the heat sink and verified the fan is good. The alarm presents immediately at power up, machine cold.
Re: Okuma VACIII D11 ALARM 20
If you want to repair, we would need to set you up in our system as a customer, send you a repair order which you would send in with the control board. Please send me your contact info (to my email in the last post) and I will contact you to discuss options.
Re: Okuma VACIII D11 ALARM 20
I give my "thumbs up" to Kevin at CNC Technical, he helped me out with trouble shooting and a replacement board for our Okuma this spring.
1 Attachment(s)
Re: Okuma VACIII D11 ALARM 20
cncts11, I have narrowed the problem down to heat damage on the PCB at the circuit that monitors the heat sink and motor thermal switches. What would I be looking at for turn around time on a repair of this nature?. I have attached a photo.
Re: Okuma VACIII D11 ALARM 20
Sorry, been out of the office the last few days - if all that is needed is the repair of the alarm 20 (no wash cycle, other repairs/updates, etc.), then it would be a same day turnaround or worst case, next day (sometimes we don't get the stuff until early afternoon and to receive it in, get it on a bench, repair it and test it might not be possible before UPS comes back for pickup). Under normal circumstances though, we usually can do it.
Re: Okuma VACIII D11 ALARM 20
Quote:
Originally Posted by
edwart28
cncts11, I have narrowed the problem down to heat damage on the PCB at the circuit that monitors the heat sink and motor thermal switches. What would I be looking at for turn around time on a repair of this nature?. I have attached a photo.
Hello,
Did you solve problem?
What parts you replace?
Re: Okuma VACIII D11 ALARM 20
Quote:
Originally Posted by
edwart28
"1058-20 ALARM A Heat Sink Overload" presents at power up (cold machine) and communication with the drive. Drive LED's M1 and M2 as well as green LED 9 are on solid. Have exhausted maintenance manual and tech support troubleshooting tips up to changing out control PCB, which I don't have Any suggestions greatly appreciated.
Hi,
did you solve the problem?
What parts do you replace?
I have the same problem and I need help my electronic technician did not find the defect.......
Re: Okuma VACIII D11 ALARM 20
As noted above, we repair these...if you are interested in getting it repaired, please contact us at [email protected].
Re: Okuma VACIII D11 ALARM 20
Merhabalar bu sorunu nas?l çözdünüz ?
Re: Okuma VACIII D11 ALARM 20
hi bro!! did you find the problem??? what elements did you change??