WorkNC Haas VM3 NEW GEN PostProcessor
Hi guys,
I'm new here, I'm looking for a postprocessor for worknc 2018 R2 for a HAAS VM3 NewGEN machine, or someone who can change my old postprocessor to give me trailing zeros in the F command.
Right now the current postprocessor has the coordinates and feed like this:
"X100.Y200. F3500"
but what I need is the following:
"X100.Y200. F3500."
If someone can help me, I appreciate it.
Best Regards
Re: WorkNC Haas VM3 NEW GEN PostProcessor
Did you get this solved? If not, look at line #30 in your post.
1 0 0 F : 30 Format of speed commands : 0=n/a
That third digit needs to be a 0 to add the decimal point after the feed.
Sorry, I didn't notice this post a month ago. This forum is so dead that its seldom on my radar to look at.
Dan