Need Help - "OT500 (X5) + OVERTRAVEL ( SOFT 1 )"

Hello,

Currently working with a 35iB FANUC system and have encountered a odd issue that I'm unsure how to proceed with. Am receiving a "OT500 (X5) + OVERTRAVEL ( SOFT 1)" alarm when placing the system into auto. Will jog fine and perform a safety test without issue. I have checked parameters 1320 (1800.0) & 1321 (-1) to ensure the x-axis position is within the limits, and it is (sitting at 178.267). Tried zeroing the x-axis out to see if that would have any effect- and it didn't.

I have also attempted inputting a CNC-PARA backup that I have from 4/21/23 as it's a known good backup.. Suspected that it might've been a parameterization issue, but it had no effect on the issue.

Any ideas?

Thanks,
TKinser