L 32 VIII Collet Dwell to allow synchronization device on the bar feeder to engage
Good morning,
I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.
Lathe: Citizen L 32 VIII
Bar Feeder: IEMCA Boss 338
Thank you,
Re: L 32 VIII Collet Dwell to allow synchronization device on the bar feeder to engag
Re: L 32 VIII Collet Dwell to allow synchronization device on the bar feeder to engag
Quote:
Originally Posted by
mazpuruav
Good morning,
I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.
Lathe: Citizen L 32 VIII
Bar Feeder: IEMCA Boss 338
Thank you,
Using the G4U## delay between open and moving could work but you could also fixe the barfeeder parameter to allow more time.
Iemca parameters #9 & #10 are delays for "Open collet thrust delay", "Close collet thrust delay".