select Macro (contour3)

Hi

I'm have the following problem on my Deckel FP4AT with Contour3 controller:

I need to produce a cube-like component part with an annular groove on each side. Now I would like to describe this groove in a macro and call in every program for every side at a specific location.
Now to my problem:
I go to my macro list when I press %0* Then I create a macro program, e.g. % 0 * 1 and then try to select it.

Nothing happens ....

a normal program can selected. I also have the problem with a local subprogram.

Who can help me???


Greetings Adam

I have not worked for ages on this controller.

As far as I can recall it, the editing the macros is similar to the N *- sentences: Usually you need to use a key combination to switch in the program editor. Try it with FKT%.

greetings
cgTNC