Re: Haas mill and lathe overvolt power problems
Quote:
Originally Posted by
dabularach
Yes i did try to clear the alarm several times. It counts down from 15 and shuts off. Every time you press reset it resets the count but thats it
Your first thoughts where right they must of been shut down too long it pays to power them up every 2 weeks just run them through a cycle spindle warm up Etc and leave them on for a few hours, they use very little power just sitting for a few hours
How old are your machines
Re: Haas mill and lathe overvolt power problems
Quote:
Originally Posted by
dabularach
They are from 2008
I have some 2008 machines that are still doing fine, I will keep an eye on them though and get a replacement kit ready, they are not hard to change with the kit they have but in your case you will of lost all the Parameters, if you did not have a Backup that could be a problem, there is normally a basic factory parameter backup in a bag on the machines main cabinet door, this may not give you everything if your machine has any extras added