Ceramill Motion 2 - 5 axis cnc - tool zero sensor wiring

Hi Guys

I have a mill i'm rewiring to a modern motion control board.

I'm just trying to create the wiring diagram before I take it all a part, though ive hit a snag wire the tool zero sensor.

It seems to be a magentic sensor that reads the movement of a metal anvil as it slides across the micro chip as the tool hits the arm.

Does anyone have any idea what the wiring on the pcb would be? https://www.cnczone.com/forums/attac...d=490122&stc=1https://www.cnczone.com/forums/attac...d=490124&stc=1https://www.cnczone.com/forums/attac...d=490126&stc=1

Ok I found out the chip is a linear incremental position sensor, that uses reverse poles over the sensor to work out positioning. It’s a AS5306 sensor so it breaks the movement down into steps like a stepper motor encoder.

Now just wondering if anyone has an idea how this could be connected to a UC300eth motion control