NakaMura Tome TMC-30

I just recently installed a new axis lubrication unit onto this machine. I'm trying to get into the parameters and change the time amount for lubrication. Found the parameters but, it's all number coded... I'm guessing. It shows a number i.e. 0267 and than a binary code i.e. 01101. I'm guessing the first number is the parameter address (What it does) and then the binary part is it's commands. How do I find out the parameter for axis lubrication. I checked all the manuals and surprisingly they don't say anything about the machines 0parameters. Can anyone help?

Call Methods Machine Tools on Monday morning, they'll tell you what the right parameters to change are, and what values to use.

978-443-5388

Have your machine's serial number ready when you call!

What do you need help with?

I need help too. I resently purchased a used 1992 tmc-35BX with a fanuc OTTC control and I need programing, opearator and maintenance manuals. I do not know if our machines are close enough but it would be great if you could help. I will gladly pay. Don

Sorry I can not help you with your problem. Howerver I have a problem that maybe you can help me with. I resently purchased a 1992 tmc-35bx with a fancuc OTTC control. I need a operator, maintenace, and program manuals.
I do not know if you machine is close to the same but it would be great if you could help me out. I will gladly pay.

I have a problem that maybe you can help me wit
http://www.ywseo.net/seo4.jpghttp://www.ywseo.net/seo3.jpg
http://www.ywseo.net/signature.jpghttp://www.ywseo.net/guilai2.jpg

gavinkong13
Not sure if you were trying to reply? I only got part of the message.
[email protected]