Mach3 G-Code-Ripper not working
I have 4-axis 6090 CNC from china,
i am using "G-Code-Ripper" to work with uneven surface copper pcb.
but when i run the file.ngc file in mach3 the output in the file gives similar values for each axis,
though while running the probing it shows proper Z values on Mach3 interface.
the output file looks like this
"
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
"
Please help me find out the problem.
Thank You.
Re: Mach3 G-Code-Ripper not working
Hey, did you ever receive a fix for this. I have a similar issue if the board is very closely level. If it's a lot out of sync then the output file seems to work,
Re: Mach3 G-Code-Ripper not working
Try lowering the accuracy values in General Settings.
Re: Mach3 G-Code-Ripper not working
Quote:
Originally Posted by
he1957
Try lowering the accuracy values in General Settings.
I have the same problem, were you able to solve it?
Re: Mach3 G-Code-Ripper not working
did you ever receive a fix for this?
Re: Mach3 G-Code-Ripper not working
Quote:
Originally Posted by
madmac4u
I have 4-axis 6090 CNC from china,
i am using "G-Code-Ripper" to work with uneven surface copper pcb.
but when i run the file.ngc file in mach3 the output in the file gives similar values for each axis,
though while running the probing it shows proper Z values on Mach3 interface.
the output file looks like this
"
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
54.97500,21.67500,-0.03750
"
Please help me find out the problem.
Thank You.
This is a problem with MACH3 and/or the controller board you are using. Other people have reported problems like this. At least one fixed it by upgrading the firmware on the controller.
I don't use MACH so I don't know more than that.