Re: Diagnostic Parameters
You may have to switch them on manually
Re: Diagnostic Parameters
Quote:
Originally Posted by
Omssrls
How di you solve your problem?
I have the same problem
Thank you
PWE =1
Check the Edit key. Should be in the OFF position.
Regards
ALex FANUC
Re: Diagnostic Parameters
my fanuc om will only allow me to change/input parameters for #500-509 using the procedure above. Any ideas how to input the rest of the parameters?
Re: Diagnostic Parameters
Have you got your parameter write enable on ? Where are you there maybe a local service depot that can assist
Re: Diagnostic Parameters
Quote:
Originally Posted by
mbservice
Have you got your parameter write enable on ? Where are you there maybe a local service depot that can assist
Yes it is enabled. I've entered all the NC parameters and now I'm trying to enter the diagnostic parameters and that is where it only allows me to enter parameter #500 to 509? Please help!
Re: Diagnostic Parameters
Press the E Stop and try if not you may have to contact Fanuc or another service engineer