mpc6515 v 2.0 with lasercut
Hi to all
thank's in advance, here is the problem:
just bought a laser engraving cutting machine with mpc6515 motion controller as motherboard (stand alone machine), the suppliers send the machine with 2 Cd's and a green softdog as the machine was sent assembled and operating, thus trying to install the software lasercut5.1 ends up with an error at the beginning with message: ""failed to get setup files"" and with lasercut5.3 the install go true but not with a complete communication with the machine, after trying to upgrade the firmware i receive now wrong files re-load configuration ,and when all set OK with lasercut5.3 i receive dll version don't much firmware version. please anyone who can help i am at a dead end with this machine and i had put all my saving for it so i can work freelance pleaaaaaase.
Sincerely you rs
Hicham.
Re: mpc6515 v 2.0 with lasercut
i want to upgrade the firmware of my MPC 6515 , is the version 4.0.3, and can not understand the files, could somedy help me?
Re: mpc6515 v 2.0 with lasercut
how can i do that my brother?
Quote:
Originally Posted by
hicham
hi and thank you again; my problem is solved but there is a think that i would like to know if it is possible, what is the most latest firmware update for the motherboard because untill now i only can upgrade to V4.1.2.3 and in the mean time i wish you all a good time...