Mori Seiki SH 5000 not moves any axis

Printable View

06-03-2013, 08:15 PM
coldrex

Mori Seiki SH 5000 not moves any axis

Hi for all!
Problem:
Mori Seiki SH 5000/40 with Fanuc 18i/MSG-501 control. (APC with 2 palets)
When turning on machine, system is booting and after massege "Open and close the door" when I open and closed the door turning on power for servo amps ATC and APC (SVU-20), in some seconds turning off it and after that turning on it again excepting APC servo amp.
Not any alarm or massage after that and not any movement.
Is there anybody who can explain me what may be the cause of this behavior?
Thanks in advance!
06-05-2013, 09:03 PM
nautomation

See the Interlocks in ladder
06-05-2013, 09:34 PM
underthetire

APC servo amp won't show much until time for pallet change. Check the MPG and make sure it's snapped in to the holder tight.
06-10-2013, 09:48 AM
coldrex

I have Servo alarm (APC) EX1664 (319).
And in manual operation do not rotating palet changer.
I am working with Mori Seiki the first time and know not so much about it.
So I need help very much.
06-10-2013, 11:26 AM
nautomation

The EX stands for External Alarm ( you can see the Details in ladder ) , Might be Check the Field Components / Fittings like , Air pressure / Proximity / Limits / Adjustments etc..
06-10-2013, 04:19 PM
underthetire

You will need to go to the PMM (power Motion Manager) and see what alarm is on the Beta power mate controller. Most likely a dead battery and need zero return.
06-12-2013, 04:19 PM
coldrex

Thanks for advices to all. It needs to set zero points so I am looking for Zero Point Adjustment SH5000-8000 instruction.
07-28-2021, 03:37 PM
Cabron

Re: Mori Seiki SH 5000 not moves any axis

Quote:

Originally Posted by coldrex

Thanks for advices to all. It needs to set zero points so I am looking for Zero Point Adjustment SH5000-8000 instruction.

Hello Coldrex,

Did you find the procedure for pallet changer zero point setting ?
I'm having same error EX1664(319) with a SH4000 with 2 pallet changer with fanuc beta amplifier after replacing amplifier's fan.
08-22-2021, 04:25 PM
jp41558

Re: Mori Seiki SH 5000 not moves any axis

Both codrex and Cabron, Have you gotten the problems fixed? Did you get the home procedures? If not please let me know
08-23-2021, 08:30 AM
Cabron

Quote:

Originally Posted by jp41558

Both codrex and Cabron, Have you gotten the problems fixed? Did you get the home procedures? If not please let me know

Hello,
Yes I got it fixed thanks to procedure sent in by DMG MORI.
02-28-2024, 11:20 PM
antoniomasat

Re: Mori Seiki SH 5000 not moves any axis

Quote:

Originally Posted by Cabron

Hello,
Yes I got it fixed thanks to procedure sent in by DMG MORI.

Hello! Could you send me these procedure, please?