Removing feed-thru punch from wood die board?
I'd like some advice on how to remove a broken feed-thru punch from a wood die board. The punches are only 1/16" thick so there's not much steel to press against when pressing it out. I'm new to this and wanted to get advice on what the standard procedure is before I try pressing them out with some sockets.
https://www.cnczone.com/forums/image...BJRU5ErkJgggA=
Re: Removing feed-thru punch from wood die board?
Need photo - it does not appear.
Cheers
Roger
1 Attachment(s)
Re: Removing feed-thru punch from wood die board?
Re: Removing feed-thru punch from wood die board?
Um ...
What's not visible is how far it is sunk into the timber. That matters.
Frankly, just looking at it, I would GUESS that brute force and a hammer might be how I would try. Sorry about that.
Unless of course you can fit a tight mandrel inside it and then apply a bit of torque?
Cheers
Roger