hello friends I have a problem on m32 machine citizen meldas 600 an alarm on the z3 axis S01 servo alarm: pr 0025
Printable View
hello friends I have a problem on m32 machine citizen meldas 600 an alarm on the z3 axis S01 servo alarm: pr 0025
Remove the electrical panel and look at the amps , what amp is in alarm?
Did you loose position on all axis, I am asking because the first alarms are ABS alarm, that position, the S01 alarm is the axis tried to move and mybe went to the end of the ball screw
Thank you for your message we found the problem that the encoders of the Z axis are defective we have changed the encoders and now the alarm and disappearQuote:
Originally Posted by Tech34
I have lost all the origins of the axes and the problem because we have changed the encoders and now the Z axis alarm 3 and disappear but we still have a problem on the emergency stop, nothing or triggered there is a message about status Emg1 emg2 emg3. I have Check the emergency stop when I press the button a message displays emg pressesQuote:
Originally Posted by h65
Z 70 is a position alarm = rehome
12 is a amplifier alarm
51 is a amplifier alarm
Good morning Yes I changed the Z3 axis encoder completely new but the problem is still EMG.Quote:
Originally Posted by h65
There is no red lamp on the desk, there is just a deposit on Orange.