Printable View
Hello everyone!
I am new here and have the following problem:
I want to create a procedure on a Fidia M1 controller in which I want to place a piece zero point from a pre-defined register.
The whole looks like this:
[...]
RG 04 -120. ;coordinate X
RG 05 -70. ;coordinate Y
.
.
.
ORIGIN 1
SET XM:04
SET YM:05
[...]
The last part (SET XM:04 SET YM:05) is the interesting part- what is the correct Syntax?
I already tried various versions without success.
Thank you in advance
Regards
michael
ADDITION:
The last part is the only register use of the procedure which DOESN’T WORK.
All other usages (e.g. >G0 X:06 Y:07 – of course register set in advance!) are carried out without problems.
So either there is no register usage indented for the command SET *M or there is a syntax error...
Another attempt:
Does t the M1 controller has another memory that I could set/read out for this operation?
Regards
Michael
That doesn’t work with your software -unfortunately- it’s too old!
From V3R10.0 the following works:
(example for a useful usage of the register)
G201H0
RG 01 = 10000.
RG 02 = 2000.
RG 03 = 3000.
RG 04 = 4000.
RG 05 = 500.
>G203
N1 (Fidia S.p.A. ISOGRAPH v. 7.0.1 07/26/06 10:53:10)
N2 (compile file: C:FIDIAProgramh1)
N3 ( HIGH SPEED DRILLING)
N4 ( T00 D 32.000 R 0.000)
N5 M03 S2000 F:01
N6 G00 X0.000 Y0.000 Z100.000
N7 G00 X0.000 Y0.000 Z2.000
N8 X0.000 Y0.000 Z0.000
N49 X4.301 Y4.874 Z-0.135
N50 X4.053 Y5.082 Z-0.143 F:02
N51 X3.794 Y5.278 Z-0.151
N100 X-6.299 Y-1.604 Z-0.540
F:03
N101 X-6.211 Y-1.916 Z-0.548
N150 X5.990 Y-2.525 Z-0.937
F:04
N151 X6.108 Y-2.223 Z-0.944
N200 X-3.250 Y5.629 Z-1.333
F:05
N201 X-3.527 Y5.460 Z-1.341
N251 X-0.486 Y-6.482 Z-1.738
F:01
N5166 G00 X0.000 Y0.000 Z100.000
N5167 M05
Finally it’s possible to write translations, rotations and reflections per G command into the NC program. But as I said only from version V3R10.0 and higher...
Regards Bert
Hello Bert
Thank you a lot for your answer. :)
First I thought that my controller version cannot do what I am planning to do after what you wrote but my controller is definitely able to write rotations, reflections etc. into the NC program..
Quote:
Finally it’s possible to write translations, rotations and reflections per G command into the NC program. But as I said only from version V3R10.0 and higher...
Like this we get feeds into a subprogram..
So is there still hope?