Printable View
Good day.
Attached are a few pics showing the modification to my mill to increase the y axis motion from 9.5" to 11.02".
I removed 1.1" of the hard stop bumper and modified the limit switch adjustment.
Take care not to increase the travel of the saddle beyond the end of the y axis ways.
I cannot guaranty the same results on your machine, so take care.
Looks like a Kurt D688 vise. I added a subplate underneath the D688 and freed up an inch of Y-axis travel from using vise keys on the middle slot with only the vise. Also I machined two removable 12mm precision holes, one round and one diamond shaped, in the mill bed and put liners in the subplate so no tramming needed.
Don
Attachment 421896
Attachment 421898
Attachment 421900