Programming tailstock advance on program osp 5000
Hey
I am making some parts that require tailstock so my program faces and centerdrill my part and I've manual reset and advanced the tailstock in MDI with M56 and restarted the program for now.
I would like to advance the tailstock in the program but I had no luck.
Tryed
M05
M157
M56
M03
But the peogram stalls after the tailstock advance.
Anyone can tell me how it's done ?
Ps. My advance pedal dosent work aswell only the retract [emoji26]
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
Do you have tailstock advance confirmation?
Normally foot pedal should work unless some interlock is preventing it Do you get any alarm? Does tailstock try to advance or doesn’t even try?
If you check your I/O is the solenoid advance signal activating?
Any other machine options that may be preventing it like part catcher or touch setter?
Best regards,
Re: Programming tailstock advance on program osp 5000
Quote:
Originally Posted by
OkumaWiz
Do you have tailstock advance confirmation?
Normally foot pedal should work unless some interlock is preventing it Do you get any alarm? Does tailstock try to advance or doesn’t even try?
If you check your I/O is the solenoid advance signal activating?
Any other machine options that may be preventing it like part catcher or touch setter?
Best regards,
I found out that the confirmation was not on so i adjusted it and not it works in auto and I can do it in the program. My advance pedal still dosent work it might be a lose connection. My retract works no problem
I got have part catcher or tool setter on this lathe.
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
I don't have tailstock and part catcher [emoji28]
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
Go into check data and look for input from foot switch. Should be next to retract input.
Re: Programming tailstock advance on program osp 5000
Quote:
Originally Posted by
OkumaWiz
Go into check data and look for input from foot switch. Should be next to retract input.
In the parameters ?
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
I can't find where I can see it the foot switch is working [emoji849]
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.
Re: Programming tailstock advance on program osp 5000
Quote:
Originally Posted by
OkumaWiz
It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.
Cheers mate. Will check it today when o get in the shop
Sendt fra min EML-L29 med Tapatalk
Re: Programming tailstock advance on program osp 5000
Quote:
Originally Posted by
OkumaWiz
It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.
I can't seem to find anything under ec inputs.
Sendt fra min EML-L29 med Tapatalk