Re: Connect Cadet CNC Lathe
Hi,did you ever get your lathe to run, I bought a lathe without software and was able to get it to run on an old windows 98 computer, i do have problems with offsets as the software i downloaded from a forum has left the conectl offset programme a read only programme.I was wondering if you could upload a copy of your software for me.
regards Roy.
Re: Connect Cadet CNC Lathe
Hi Roy,
A bit late but it might help.
The original DOS software runs very well using DOSBox X on a modern PC (mine is windows 10)
I have used all the versions of DOSBox but I prefer X as its easier to set up.
You can make DOS files read and write using the "attrib" command in dos or at the command prompt.
Hope this helps.
Regards,
Keith