Printable View
I have an old custom machine with a Fanuc Series 15-M PMC and 14 axis'. I need to do some modifications to the ladder program but I am currently unable to upload it from the PMC. I've tried FAPT Ladder I, II and III with no luck. I've also tried using a Handy File without any luck. Is it even possible to upload the ladder program using a pc? Or is this model too old?
I would appreciate any advice or assistance.
Thanks,
Greg Elliott
Controls Tech
Hi Greg,
I write quite a few ladders but have never done one for a 15, however I have the manual for all Fanuc pmc's and will get all the information in the morning.
If you still need it then, maybe someone will have the answer before.
I cant remember if the 15 pmc was in eprom or not if so thats a problem.
Regards
Hey Greg,
I will be out on service until tomorrow finishing up a retrofit, I will scan the pages you need and get them to you on Saturday.
Thats about the best I can do.
Regards
Sounds good to me debco99. Whenever you get a chance that would be great!Quote:
Originally Posted by debco99
Thanks,
Greg
Greg, I have the information you need (pdf's) get in touch with me at
[email protected]
Regards
Hi I have a problem
I need to open a pmc ladder RB2 but whit the version 3.4 and 4.2 is impossible
can you help me?