Tsugami - main/back spindle rotation phase synchronisation control

Hi,
Just got the new Tsugami HS265-5AX and I'm looking for some information or documentation for setting up the back spindle.
I'm working with a special collet which has an inside form (it's not round). I would like to synchronise the main and back spindle rotation/phase. My problem is just how to handle the two parameters 4135 and 4034?

I have to correct a mistake from my back spindle which is about 37 degrees off with the main spindle?

After that how can I check if my correction is fine with the MDI mode?

The explanation from the instruction is not so easy and I really would like to do it that way.

Thanks for your help.

Email me your contact information, I'll send you the proceedure. The manual is correct, a bit difficult to understand the first time thru. Please note,there must have a keyway in the shaped sub collet, a 3mm pin needs to be inserted into the collet sleeve adapter to pin the collet prior to phase adjustment.

Rob
Tsugami/Rem Sales

Hi,
Did you already send me the document?