EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
Hi! Im machining a contour with a small diameter tool using a ROUGH MILL with WAVEFORM strategy. The toolpath is starting on the piece with an helix motion. The setting gives us two option: pre drilled hole and helix. How can i make the toolpath ROUGH MILL WITH WAVEFORM strategy to start from outside to inside ? Thanks in advance !
1 Attachment(s)
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
Hi!
I think your option "stock type" isn`t choosed, if you choose "Current Stock" it should be starting outside of the part. IF you have inserted a stock :)
See my attached picture.
Attachment 419922
Greetings from Robert
1 Attachment(s)
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
Quote:
Originally Posted by
Vegabond
Hi!
I think your option "stock type" isn`t choosed, if you choose "Current Stock" it should be starting outside of the part. IF you have inserted a stock :)
See my attached picture.
Attachment 419922
Greetings from Robert
Hi Robert and thank you very much for your reply. I have tried as you suggested but i still can not get the toolpaths to start from outside to inside . Surely there is something that im missing. Here are attached some files for your consideration.Attachment 419942
1 Attachment(s)
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
1 Attachment(s)
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
Quote:
Originally Posted by
mousongie
Hi Robert and thank you very much for your reply. I have tried as you suggested but i still can not get the toolpaths to start from outside to inside . Surely there is something that im missing. Here are attached some files for your consideration.
Attachment 419942
Attachment 419952
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
Quote:
Originally Posted by
mousongie
Are you using a boundary? Try without.
If you only want to rough the outside, then pick 2 boundaries:-
The 1st the part profile
The 2nd a rectangle bigger than the billet - it's size really doesn't matter as long as the cutter can easily fit between it and the billet. You will have manually create this.
Play with boundary options (in/out etc) in roughing to see different results.
Re: EDGECAM ROUGH MILL STARTING WITH AN HELIX MESSAGE
OR milltype from optimized to CLIMB MILL! :)