Printable View
I wanted to see if anyone else has had issues with the NEW C11G boards. I got my first one and if the PC was not in "run" condition the Relays screamed and the analog voltage was zero. I was sent a second board which still had the relay screaming. Then they sent me a third board and it worked for about a month now its doing the samething.
Anybody else got these issue or am I just the lucky guy?
Please tell me more. Do you have a ticket number?
Arturo Duncan
https://cnc4pc.com
No I was trying to see if this is my setup. This board is starting to do the samething the other 2 you sent me were doing. Can you tell me what is wrong?Quote:
Originally Posted by arturod
I have no idea of who this is. You talk about a problem with a C11G board that we sent. I do not recall a case of bad C11G? You talk about several boards? I have no clue.
Arturo Duncan
https://cnc4pc.com
Neil Cunningham in Charlotte NCQuote:
Originally Posted by arturod
I was the one that reported the screaming relay. Then you sent me a working board and now that board is starting to do as the others. I just wondered what you found and could my setup be an issue. I have had this third board for a month or so.
I had put in ticket numbers for the other boards...
Neil,
YES!!! I remember you. I remember the case with a batch of boards due to a resistor out of specs. As far as I can tell off the top of my head, we replaced all those boards. What is the issue you are having now?
Arturo Duncan
https://cnc4pc.com
Yes you did .. but the new board is starting to do the same thing.
Not every time but it has happened a couple of times when I started up the controller. When MACH get control the issue always stops..
Sent from my XT1635-01 using Tapatalk
My 11G board does the same thing....actually i am not using it any more but i did notice it when i used it from the start.
How old is your boardQuote:
Originally Posted by ericks
Sent from my XT1635-01 using Tapatalk
Less than six monthsQuote:
Originally Posted by truckeic