Printable View
Hello everybody!
Is there a program with help of which I could create a list of required tools from my NC-program?
The program should work similar to TDi from Siemens. Unfortunately our “old” Heller has a UNIPRO-controller.
We use an old tool on DOS-level but we’re searching for something for Windows.
I’ll be glad to receive a couple of replies.
Greetings
Dirk
HiQuote:
Hello everybody!
Is there a program with help of which I could create a list of required tools from my NC-program?
The program should work similar to TDi from Siemens. Unfortunately our “old” Heller has a UNIPRO-controller.
We use an old tool on DOS-level but we’re searching for something for Windows.
I’ll be glad to receive a couple of replies.
Greetings
Dirk
There’s CELL-system from Heller (works with uniPro80 and uniPro90). But it’s unix-based. It helps to plan required / unneeded tools. At the start the tools are determined in an NC-program. Then there’re requirements lists determined under network access.
HiQuote:
Hello everybody!
Is there a program with help of which I could create a list of required tools from my NC-program?
The program should work similar to TDi from Siemens. Unfortunately our “old” Heller has a UNIPRO-controller.
We use an old tool on DOS-level but we’re searching for something for Windows.
I’ll be glad to receive a couple of replies.
Greetings
Dirk
There’s CELL-system from Heller (works with uniPro80 and uniPro90). But it’s unix-based. It helps to plan required / unneeded tools. At the start the tools are determined in an NC-program. Then there’re requirements lists determined under network access.