Hello
I’d like to use the second line of the output of the MSG instruction.
Is it possible to use the second line directly?
I tried to make it with “%n” or with counting of symbols. It doesn’t work because there’s no proportional font used.
Regards
Printable View
Hello
I’d like to use the second line of the output of the MSG instruction.
Is it possible to use the second line directly?
I tried to make it with “%n” or with counting of symbols. It doesn’t work because there’s no proportional font used.
Regards
Good evening
Well, the controller divides a message automatically if it has more than 62 symbols. There’re maximally 124 symbols allowed for a message, so 2x62 symbols. So just enter so many spaces in the first line that you’ll come into the second one…
Regards, guschdel
Hello
It would work this way at our Embedded. But the font of the Advanced isn’t proportional. So that I can use more “I” in the first line than “W”.
I don’t know how I may/can change the font.
Regards