3 Attachment(s)
Fanuc series 18 i-M, Daewoo diamond series DMV-500s start up error
Hail from Jamaica,
We have a Daewoo diamond series DMV- 500s with a Fanuc series 18i-M computer attached. We are having a startup issue, the machine is stuck at this screen:
GRAPHIC IS READY, BOOT STARTUP
We have four green LED and two red LED in the back not sure of the error code
PLEASE HELP!!!!!!!!!!!!!!!!
Re: Fanuc series 18 i-M, Daewoo diamond series DMV-500s start up error
Most likely a bad CPU. Replace it. Make an SRAM backup in boot mode first before removing the yellow case.
If you do not already know, the CPU is located on the right when looking at the lights, as in your pictures. It plugs directly into the main board.
Re: Fanuc series 18 i-M, Daewoo diamond series DMV-500s start up error
Is there a way to troubleshoot the system so i can know for sure that its the CPU?
- - - Updated - - -
Thanks for the reply
Re: Fanuc series 18 i-M, Daewoo diamond series DMV-500s start up error
Unfortunately, not really. Make the SRAM backup if you can and remove the other 2 larger modules on the main board and see if it boots up. If not, then it's either a CPU or Main board. Also, you could try clearing memory on startup(obviously make sure you have a good backup). Sometimes corrupt memory will make this happen.
Re: Fanuc series 18 i-M, Daewoo diamond series DMV-500s start up error
hello friend excuse me do you have the backup of that machine because I losto the parameters, macros and all,
this is my email [email protected] if you send me the backup please because the machine is stopped
thank you
regards