Re: First time CNC project
My guess is that the problem is with the cables from the drives to the steppers and you may have one pair incorrectly connected.Do you have the means of checking which pairs of the motor connections are on the same circuit?I had a similar problem getting my steppers to work with LinuxCNC.
Re: First time CNC project
Hi Damoros - Check you are getting voltage out of the phone charger. Phone chargers have circuits that shut down the charger if the current is low ie the phone is charged or disconnected. Since the charger is expecting amps and the control circuit uses very small current this maybe the issue. Other wise check, check and more checking... Peter
Re: First time CNC project
Hi,
Thank you both for your reply! I actually found the problem :D
I needed to connect the enable terminal (ENA) to the 5V terminal..
Did that and a green "active" LED lighted up on the board and the motors worked perfetly :D
Again, thank you for you help! Really appreaciate it! <3
Br
Joachim