NEED HELP!!! Fanuc OM AXIS INTERLOCK
Recently I purchase a Supermax 1 Rebel, Changing the parameters for use a DNC software accidentally turn off the machine before restore the PWE to 0. When I restart the machine I cant move any axis and it show a massage " axis interlock". I need help! Thanks Folks!!!
Re: Fanuc OM AXIS INTERLOCK
Hold "P" key and "CANCEL" at the same time, power on the control, this should remove the alarm and allow you to move the axes away from OT switch.
Re: Fanuc OM AXIS INTERLOCK
Cincyice58, Thanks a lot!!! The cnc is moving again!!!
Re: Fanuc OM AXIS INTERLOCK
Re: Fanuc OM AXIS INTERLOCK
I have a supermax mill just purchased it. It came without parameters, I could read only scrambled letters and numbers. I reentered all parameters from the data sheet found.
I have an alarm so far "operator message" 2000.
Any ideas...
Re: Fanuc OM AXIS INTERLOCK
Quote:
Originally Posted by
AndrewHarrison
I now have this machine. Did you ever figure it out. Im in Post Falls
TENGO EL MISMO PRBLEMA NO ENCONTARSTE SOLUCION
Re: Fanuc OM AXIS INTERLOCK
En aquel momento se encontro que la presion de aire que matiene el carrusel de herraminetas arriba no era suficiente , el control fanuc detectaba que el carrusel de herramineta estaba fuera de posicion.