I desperately need some help setting up a viper250 servo driver

I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
Any help would be greatly appreciated.

Quote:

---

Originally Posted by skypilot

I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
Any help would be greatly appreciated.

---

I know this is an old posting, but certainly a valid question.

I too own a 250 which I will be dropping into a retrofit. Here is Larry's response to the question:

The bottom 2 are step multiplier same as V200. the top one isn't used.
The drive only has 1 bank.( not 3 like older V200F)

Just an FYI for those who will be purchasing this product in the future.

Mark