2 Attachment(s)
PWM or TTL control of 15W chinese laser via bitsensor motion controller?
Would need som help to figure out how to wire and get the laser control to work.
My setup:
Mach3
BITSENSOR 4 Axis CNC MACH 3 USB Controller
15W Blue Laser with 12VDC powersupply.
Laser has the following connectors:
[+ (+12V)] [ - (0V)] [PWM/TTL]
[-] TTL/PWM [+]
Bitsensor has the following pins for analog/PWM:
[10V] [5V] [GND]
[AVI ]
[ACM]
I have successfully got the 0-10V control to work when hooked up with a 10V supply to [+10V] [ACM] and [AVI] for the "signal" but I'm not sure how to wire it with the laser as there are several different voltages at play and no documentation available.
Now I'm controlling the laser by shorting the [-] TTL/PWM [+] pins with a relay (NC) controlled by an output.
Would be gratefull for any help with this.
Re: PWM or TTL control of 15W chinese laser via bitsensor motion controller?
I have recently come upon this post of yours and I have exactly the same setup. I got my laser to work and everything. I also have the same question on the RNRMOTION controller. How can I get the M11 and M10 commands to work. Did you have any luck?
Re: PWM or TTL control of 15W chinese laser via bitsensor motion controller?
Did you guys get M10/11 working? I am trying to get it working on my rnr motion controller as well.
thanks,
Brendin
Re: PWM or TTL control of 15W chinese laser via bitsensor motion controller?
RNR boards do not support M10/M11
So much on cheap clones of clones of clones boards.