P300SA Graphic Simulation Problem

Hello and sorry for my english

I have a little problem with Graphic 2D/3D Simulation on OSP-P300SA

So... if i start REAL my program, graphic simulation work great.

Now, if i block the machine and i try the simulation of the same program, work great.

Problem is if i try to start a simulation without try first time the program in real condition.

I look the graphic of all the Tool only vertical or horizontal. If B axis is REAL vertical, i look all in vertical. If B axis is REAL horizontal, i look all the graphic horizontal.

So, only the first time i try the simulation i have this issue.

Any solution?

Thank you really so much and sorry for my english.

(in CAS i look all good, only in 2D/3D simulation i have this problem)

hy andytpks, i have used available graphics a while ago, but meanwhile i have seen that there are faster methods to check a setup

what i remember, for osp300, is that there are 2 graphics libraries, that are, somehow, interlinked :
... the one configured inside the 3d model, that is registered to turret posts, then being used by cas
... the one configured inside igf

if i remember correctly, cas & animation, use the same graphic library ( but on older cnc models, animation was using codes that were spit by igf )

in your case, it seems that B axis position is always displayed ok in cas, but in animation it requires to have the programmed allready executed

hmm
... cas & program execution are co-related, thus you can't run one without the other ( well, you can disable one of them, like turning cas off, or using the machine in lock-mode, but still the co-relation will be there )
... animation is not related to cas, nor to program execution, but to motion simulation; it is possible that it displays the motion correctly, but the real axis position is not updated, unless the program was executed before

Quote:

---

Any solution?

---

if you run the machine only in "lock-mode", then "in animation", try to run it before in "lock-mode & dry-run", so to shorten the wasted time :)

i am not sure, but i believe that maybe you are experiencing an issue with wcs-update ?! i don't know, i would need to see more details about what's happening, like, for example, share a short video, capture your screen

but, if you use cas, why do you also bother with animation ? kindly :)