I need technical support for Deckel FP50CC please

Machine Supplier: Deckel

Machine Type: FP50CC

Serial Number: 2813-0234

Machine control: Dialog 11
Attachment 453124Attachment 453126Attachment 453128Attachment 453130
The problem is as follow:



When the system starts, the sequence of starting runs normally and then it finally gives the indicated status in attachments.

Pushing green control ON button in the operator panel has no effect i.e. (drives not start), the machine then gives no error messages and no alarms as indicated in attachment "monitor1.jpg". But the abnormal behavior is that after the sequence of starting is finished:

The (READY) led in the NPC card is ON whereas the (RUN) led in this card is OFF as indicated in attachment "Dialog11.jpg"
The (CNC) led in the NSV card is OFF as indicated in attachment "Dialog11.jpg"
Please give help to fix this problem

Try https://www.practicalmachinist.com/v...a-abene-mills/. There are very experienced people there.
Note to Moderator - I hope this post does not contravene forum rules - I'm just trying to assist the OP.

Bill

That was meant to be practicalmachinist.com/vb/deckel-maho-aciera-abene-mills/ but it came out wrong.
Bill

Quote:

---

Originally Posted by WCD9

Try https://www.cnczone.com/vb/deckel-ma...a-abene-mills/. There are very experienced people there.
Note to Moderator - I hope this post does not contravene forum rules - I'm just trying to assist the OP.

Bill

---

This website is no longer available

Praise be to Allaah
My machine has been repairedAttachment 455058Attachment 455058Attachment 455060

The same problem is repeated again