I'm going to purchase an XHC WHB04B-4 pendant, but I can only find them from China, just wondering if anyone has bought one from anywhere else or recommend a good dealer from China I can count on.
Thanks Mike
Printable View
I'm going to purchase an XHC WHB04B-4 pendant, but I can only find them from China, just wondering if anyone has bought one from anywhere else or recommend a good dealer from China I can count on.
Thanks Mike
Hi,
XHC have a poor reputation for supporting their devices. They have a plugin for Mach3 but to my knowledge not for LinuxCNC,
are you sure that it would work with your setup?
It may mean that you'll have t write your own plugin and probably with little or no support from XHC.
Craig
There is driver support in linuxcnc for your model XHC-HB04
And for the newer version XHCâ??WHB04Bâ??6
I can't comment on either.
XCH actually make some higher quality commercial pendants which are nice and what I use but they consume a lot of pins if fully configured (I have on Mesa hardware)