Piranha PJCM 2030-3 Communication Problems

Hi All
Recently our PC crashed which we use to work with our Piranha PJCM 2030-3. When we got a new Hard Drive and reinstalled the Controller software it would still not connect to the CNC. I suspect it has something to do with a Ethernet to 15 pin serial type cable that is between the PC and CNC. There are no techs i can find to help with this. Manetech don't seem to know.

Is it protocol settings for the ethernet port? I've attached a few pics.

Hello,

we are having the exact same issue and I was wondering if you managed to get to the bottom of the issue? I have tried looking for drivers and software that could help with the serial over Lan connection but I can't seem to get this working.

Kind Regards,
David McDermott