1 Attachment(s)
What Controller for Step-Syn Motors?
I built a CNC machine 6 years ago and purchased the cheapest step motors I could find.
It worked but the travel was 11" per MINUTE!
It's time to build again and I have 4 Step-Syn motors out of an old embroidery machine.
They are 103-8573-5612 / 1.5 Amp / .72 degree per step / 10 wire motors.
Question:
What controller will drive these things?
Do I need a power supply?
I have no clue and can't find anything on these motors.
Thanks.
Attachment 337452
Re: What Controller for Step-Syn Motors?
Wait... 10 wires? Really?
If you have an ohm meter, can you check out the leads and see which wires are connected via a coil to which other wires? I'm curious to know how many coils are in the thing.
As to your new machine, I would really suggest finding some more standard motors. This page may help:
Good Unipolar Stepper Motors
Re: What Controller for Step-Syn Motors?
It's a 5 phase stepper motor if it has 10 wires. You can find old Vexta 5 phase stepper drivers on eBay sometimes.
Re: What Controller for Step-Syn Motors?
Quote:
Originally Posted by
jfong
It's a 5 phase stepper motor if it has 10 wires. You can find old Vexta 5 phase stepper drivers on eBay sometimes.
I'm so sorry for having to ask the following question.
Would each motor require it's own driver?
Re: What Controller for Step-Syn Motors?
Quote:
Originally Posted by
kbeard
I'm so sorry for having to ask the following question.
Would each motor require it's own driver?
Yes every motor requires its own driver.
Re: What Controller for Step-Syn Motors?
Wow. I think I'll reset and just go with a prepackaged new set.
Too much to worry about trying to get old motors to work with unknown controllers.
Thanks
KBEARD, you still have those Step-Syn (103-8573-5612) SANYO DENKI STEPPER MOTORS w
Quote:
Originally Posted by
kbeard
I built a CNC machine 6 years ago and purchased the cheapest step motors I could find.
It worked but the travel was 11" per MINUTE!
It's time to build again and I have 4 Step-Syn motors out of an old embroidery machine.
They are 103-8573-5612 / 1.5 Amp / .72 degree per step / 10 wire motors.
Question:
What controller will drive these things?
Do I need a power supply?
I have no clue and can't find anything on these motors.
Thanks.
Attachment 337452
KBEARD, you still have those Step-Syn (103-8573-5612) SANYO DENKI STEPPER MOTORS,
with you ???