Re: EMCO PC Turn 50 Lathe
Yes, machine has been as is since last time to try wake it up.
Drove 500 miles to get CNC Lathe - Now what
Quote:
Originally Posted by
mleppanen
Do you still have these problems? We just got one running here in Finland and perhaps can help you.
Retiree/CNC Student...
Just acquired an EMCO PC Turn 50 w/ GE Fanuk Series-O Board.
I believe it has the ACC upgrade (don't really know what that means...).
Got the ACC install instructions (Only literature that came with it.) and as near as I can tell the ACC has been installed.
No Install/Operation manuals, No CDs, No Media, No idea where to start.
Looking for any CDs, Manuals or Illustrations to get me going.
Please provide guidance, I will be eternally greatful.
Need operational Digital Media and Instruction Manuals
Retiree/CNC Student...
Just acquired an EMCO PC Turn 50 w/ GE Fanuk Series-O Control Board.
I believe it has the ACC upgrade (don't really know what that means...)
Got the ACC install instructions (Only literature that came with it.) and as near as I can tell the ACC has been installed.
No install/operation manuals, No CDs, No media, No idea where to start.
Looking for any CDs, Manuals, Illustrations or guidance to get me going.
It appears that I may have to dig out one of my old 486 computers... Is that correct?
Please provide guidance, I will be eternally greatful.
Dick N.
Re: EMCO PC Turn 50 Lathe
mleppanen, you has not been here for long time, but i still has same problems.
Re: Need operational Digital Media and Instruction Manuals
Quote:
Originally Posted by
DNukem
Retiree/CNC Student...
Just acquired an EMCO PC Turn 50 w/ GE Fanuk Series-O Control Board.
I believe it has the ACC upgrade (don't really know what that means...)
Got the ACC install instructions (Only literature that came with it.) and as near as I can tell the ACC has been installed.
No install/operation manuals, No CDs, No media, No idea where to start.
Looking for any CDs, Manuals, Illustrations or guidance to get me going.
It appears that I may have to dig out one of my old 486 computers... Is that correct?
If the machine has ACC any PC will do. Contact Emco with your serial number and they will get you all the documentation and software you need.
Re: EMCO PC Turn 50 Lathe
Quote:
Originally Posted by
MauriH
Hi Leppänen,
I need help with EMCO PC 50 lathe here in Finland, urgently.
Terveisin
Mauri
I have emco pc turn50 with i/o card and software and manuals. However machine wont go to reference. And communication with pc/emco is not fully functional.
nollaviisnollakolmeneljäkolmeysineljäneljäkolme txt
Re: EMCO PC Turn 50 Lathe
There is need some help here too :) I have software disk and i/o card and cables, but machine is not going reference. Manuals is not helpful. So- any help?